Serviette Holder - Santa

This Christmas Craft shows you how to make a Christmas Santa Serviette holder perfect for Christmas table settings, Christmas Parties and Christmas Table  Decorations.

You will need the following felt

Red- 11 3/4 x 4"  (30x10cm)

White - 4 1/4 x 4" 1/4 (11x11cm) 

Black - 2x4" (5x10cm) 

Flesh - 3x4" (7 1/2x 10cm)

Using the pattern below  



(pattern should be printed end to end on an A4 sized paper may require re-sizing)

 Cut out all the pieces then glue in the following order.

Body - Lay flat

Head - Bring the face slightly down over the coat.

Hat - Halfway over the face

Arms - Only glue the edges down so you can slip the serviette into position.

Hand - only one is needed.

White trim - on cuffs/bottom of coat/hat

Boots - A small amount of glue on top (make sure they are on the back)

Mouth - under the beard slightly

Beard - Make sure his beard comes up as far as the hat trim.

Nose - you could use a circle or a smal pom pom

Eyes - Highlight with glitter paint if preferred.

 

 

 

 

 

Like it? Share it!   

Leave your comment on this project (no HTML and keep comments to 255 characters or less). While a rating is required, an actual comment is optional.

Rate this project (Click on a star) (Required):

  Check this box to be notified when new comments are added to this project